Bandit mk1 to bandit mk2 loom

[Jdeac1981]

Hi all been looking for info on bandit looms. I've been offered a mk2 bandit loom but I have a mk1 engine.

 

my question is can I switch to th mk2 loom if I also switch cdi etc.

hope someone can help. Cheers in advance

 

jon

[fatblokeonbandit]

easy peasy, get a mark 2 pick up, neutral switch and alternator and all wil be fine no chopping plugs all fits together simples.

oh yes you need to attatch the speedo pjck up to the output shaft,u less you have a speedo drive on the front wheel and mark 1 clocks??

[Jdeac1981]

Thanks for the reply.

couple of things

by mk2 pick up do you mean ignition pickup? If yes is that a straight forward swap (remove old mk1 bolt in mk2)

 

neutral switch and and alternator I take would be a straight swap

 

speedo drive is this important as I was going to run digital clocks with magnet pick up

 

soerry for all the questions I've only ever done work on the oil cooled Gsxr 750's

 

cheers jon

[fatblokeonbandit]

yup straight swop, the 3 little screws are loctited in and made of cheese, so plan on replacing  them..

neutral switch two screws, mind the spring and plunger dosent fall out,

alternator just swops, bearing in mind the drive gear engagement problem..

 

i used mark 2 bandit clocks so wanted the spedo sensor to work, so fitted a mk2 600 sprocket cover with the leccy sensor, and drilled and tapped  the gearbox shaft and fitted the castelated rotor..

[Jdeac1981]

Cheers for answering my questions. 

I take it there would be now affect to other parts of the loom leaving the speedo wires disconnected?

Cheers jon

[fatblokeonbandit]

cant see why it would affect it

[busa ash]

as garry says its easy , i have just had the same info from him on a pm and all is good