Efe gsxr 1000 k2 swingarm

[Bigkenxx]

Has anyone done this swop ? I have a gsxr 1000 complete rear end lying around , I have a gsxr banana arm in my efe and fancy putting the 1000 one in ? Can anyone throw any light on it before I strip it . 

[Duckndive]

26 minutes ago, Bigkenxx said:

Has anyone done this swop ? I have a gsxr 1000 complete rear end lying around , I have a gsxr banana arm in my efe and fancy putting the 1000 one in ? Can anyone throw any light on it before I strip it . 

I Put K6 front & rear ends in one ..doubt there's much difference

http://oldskoolsuzuki.info/forums/index.php?/topic/1112-another-efe/&page=1

 

[Bigkenxx]

6 minutes ago, Duckndive said:

I Put K6 front & rear ends in one ..doubt there's much difference

http://oldskoolsuzuki.info/forums/index.php?/topic/1112-another-efe/&page=1

 

Thank you for reply will have a look at that link is the spindle size different to the banana arm ? 

[Duckndive]

Not sure never had a water boiler arm...

 

[Bigkenxx]

Cheers fella for your help 

[homer]

Scroll down and you will find the swingarm measurements

http://old-skool-suzuki.proboards.com/thread/612/fork-conversion-chart

[Bigkenxx]

Thanks homer 

[Bigkenxx]

Well the pivot width is good but the swingarm bolt is smaller than the k2 it's do able if you used the wn bearings etc but I might for now spray the banana arm black use it this summer and do it next winter I want to get it back on the dyno soon so don't want to mess to much