SFC Posted June 19, 2020 Posted June 19, 2020 ive got an 1100m engine with 36mm bandit 12 carbs fitted, ram air filters , v&h sidewinder exhaust (baffled) proberbly been asked a million times but here goes , anyone know a working setup as at the moment its running rich with a lot of pops and bangs, think i got 148 mains in at the moment ?? all suggestions appreciated Quote
Oilyspanner Posted June 19, 2020 Posted June 19, 2020 I'd check what jets you've got SFC, 148 would be a dynojet size, not mikuni, it might have d.jet kit fitted - you can only use their jets with their needle jet and needle, they flow differently to the mikuni jets.Mixing d.j. and mikuni is a nightmare, a real arse ache ! Most running is on pilot and needles - does it run okay at tick-over, low speed cruise and moderate throttle opening and revs ? Check what jets are in the carbs because that changes any settings given. Mikuni jets have the square in a square logo on them, jets go up in 2.5 sizes (ml per minute) - I think dynojet normally have dj plus numbers on them and sizes go up in twos (based on measured diameters and not flow). 1 Quote
Gixer1460 Posted June 19, 2020 Posted June 19, 2020 IMO - yes DJ size and waaaay too big for a near enough std engine - I'd try 126 - 130 mains. Emulsions / needles could be worn which also won't help and promotes rich condition. If they are DJ - they have a lifetime warranty & free replacement! 1 Quote
SFC Posted June 19, 2020 Author Posted June 19, 2020 massive thanks to both , will investergate more , was running geat with 12 engine ane yoshi op[en exhauast dur soon ads i put sidewinder on it was a little shit , blew 12 engine and now got 1100m so need to start again Quote
Baron Posted June 21, 2020 Posted June 21, 2020 Sorry for being curious but how can u blow up oil cooled engine? Quote
Gixer1460 Posted June 21, 2020 Posted June 21, 2020 1 hour ago, Baron said: Sorry for being curious but how can u blow up oil cooled engine? Shed loads of nitrous or 30+ lbs of turbo boost will be a good start LOL! Quote
SFC Posted June 22, 2020 Author Posted June 22, 2020 (edited) Not sure but the oil pump failed and smashed then dried up me cams. My nos was not on I was just ticking over, heard a cracking noise and switched off when I restarted it started to squeal, took head off , knackered cams . Took sump off and full of trinkets Edited June 22, 2020 by SFC Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.