1993 GSXr750WN exhaust help!

[Mopo710]

Hello! this is first time posting, but I know what OSS is about so dont hold back Im ready for all the abuse/help/banter lol

 

I have a 1993 gsxr750w, I need a full exhaust system for it. Ive seen a system off a 1994 1100wp for sale. Does any know if this will fit? I was hoping it would as both being water cooled versions.

 

if not does anyone have suggestions of systems that fit?

 

[Gammaboy]

Apart from the difference in height due to the taller barrels, from memory the sump configuration is different, so yes, you could fit a 1100 exhaust but you'd have to fit a 1100 sump (and oil pickup I think), and the it would hang low because of the shorter barrels.

[Mopo710]

Thanks Gammaboy! 

I have read about some people swapping and changing exhausts across models without changing sumps and just adding some 'manipulation' to the exhausts, a small bend or extra 'dent'. Is this do able here do you know?

[Gammaboy]

From memory, no. 

You could look at adapting a K series GSXR exhaust, there's some tweaking of the header spacing and some bending required, can't remember the details, was years ago I was looking at it.

[Blubber]

5 hours ago, Mopo710 said:

Hello! this is first time posting, but I know what OSS is about so dont hold back 

 

How about posting an Intro then?

 

Happy to fulfill your expectations...

 

 

[Mopo710]

On 4/1/2020 at 5:30 PM, Blubber said:

How about posting an Intro then?

 

Happy to fulfill your expectations...

 

 

Haha blubber thats better! I wasnt getting a bit worried I hadnt had a proper OSS welcome yet!!

[Mopo710]

Intro-Ive graduated from a DR350 supermoto to a  Blandit to GSXR750WN.

 

Any GSXR help and tips welcomed-but in particular I'm stuck for an exhaust atm!

 

Anyone selling anything that fits or any suggestions?

Edited April 5, 2020 by Mopo710

[markfoggy]

All the water boilers essentially have the same cases, the bigger ones get a little longer in the barrels,  but it's only by a mm or 2...Also the cases and  sumps are almost identical in size to all the Boilers.

I am not saying that a £1000  hand made Japanese exhaust will fit without any issues, but something reasonably priced off the interwebs will heat and a little persuasion  may be required. Boiler exhaust spacing is not the same as oil boilers, but again. not a huge difference, needs persuasion.  

Blandit 650/1250 is probably your best bet, cylinderhead is spaced right, but I'm not sure yet how it works around the sump.