Fergie1050

Check the oil seal on the revcounter drive. I had it leak on mine and oil ran down the centre of the engine.

Sorted! I removed the shaft, refitted the casing, then dropped the shaft back in. Adjusted to take the play out and everything worked out !

Will do. Thanks guys

I’m going to strip it back down this weekend. It was working before I changed the plates and springs. It’s obvious I must have messed up something

Yes that is exactly what I did, the arm moves but there is no return action. It just “flops” about …..

Just the plates

Yep, with the lever and cable connected, the arm will only move a little and not move the clutch.

Ok is not the short arm on top, it’s the shaft that runs down the depth of the casing, as per the photo

Thanks but it is facing the rear. I can get them to mesh so the casing goes on, but the clutch arm doesn’t engage

Hi, I’ve changed the clutch on my GS1000, but I’m struggling to get the release thrust piece to engage with the release shaft pinion, when refitting the primary drive cover. Do I need to remove the release shaft before locating? The manual just says” ensure the teeth engage “