Gsxr Slabside engine mount spacer dimensions

[MooreMatthew]

Anyone got the dimensions for the rear engine mounts for the slabside 

hopefully get some made tomorrow at work so can bolt engine in properly 

thanks 

Edited November 6, 2018 by MooreMatthew

[Swiss Toni]

I measured mine before I took them out. I'll see if I can find them. We are talking 750 here, aren't we?

[CockneyRick]

Bit hard to measure, better off with a cardboard template & have em made from that. I got a box load, so i'll look what's there. 

7 &11 ones are different at the front, not sure about bottom or rear tho? 

[Swiss Toni]

Forgot you'd just scored yourself the 1100! From Alpha Sports fische. 

Top right @ 46mm

Top left @ 59mm

Bottom right @ 27mm

Hope that helps!

[CockneyRick]

Lost me there? What's that you're measuring?

Mounts are triangular, so hows that a measurement?

This is a 750 front.

Edited November 6, 2018 by CockneyRick

[CockneyRick]

Right had a dig & came up with these. 3x cardboard templates for GSXR750F/G/H plus a pair of rears.

2nd pic shows them on right, the ones on left are very close but just slightly out, so possible GSXR1100G/H rears?

[Swiss Toni]

He's asking for spacer dimensions, Riccardo!  

[CockneyRick]

Oh, fairy muff.

But he does say Mounts?

[CockneyRick]

Just measured 1100 engine in a 750 frame & i got

top left 50mm

top right 56mm

bottom right? couldn't get at it 

So does that mean the 11 engine casing mounts at least 6mm nearer to left of frame?

Edited November 6, 2018 by CockneyRick

[MooreMatthew]

Thanks everyone 

Tony is right 

Great help as always from the forum 

[MooreMatthew]

Weird how got 2 different measurements 

I would have thought the rear mounts would be the same

[CockneyRick]

Casings must be major different? However mine is an GSX1100F engine! And the spacers were made to fit.

I just put engine in with front/bottom & rear mounts. Once in place i just measured the gap between the rear frame/mount to the casing & had them made up  

[Swiss Toni]

For the bottom spacer in a 7/11 I had, I made an adjustable spacer out of a big bolt and sleeve. Engine stud goes through it, as per normal, spacer opened out to remove all free play, tighten locknut. Seemples!