Ben Slabby Posted October 28, 2017 Posted October 28, 2017 What causes this? I can't see what's out. I've pulled it apart then refitted everything as per manual. I assume they're supposed to be a closer fit than this... any suggestions? Quote
Duckndive Posted October 28, 2017 Posted October 28, 2017 51 minutes ago, Ben Slabby said: What causes this? I can't see what's out. I've pulled it apart then refitted everything as per manual. I assume they're supposed to be a closer fit than this... any suggestions? a pic from the side with both seats would be good.... but bent or twisted grab rails don't help ...have you got all the right spacers and washers under the front mount...check the rear mount brackets are not bent... and its not unusual for the rear frame rails to be slightly bent the seat panels have rubber covers on the tabs when new but they don't make much odds ... Quote
Dorkburger Posted October 28, 2017 Posted October 28, 2017 My current and past EFs were both like that. Seeing as how the plastic panel screws to the seat, I was going to take a bit off of the rubber pads where the seat rests on the frame to close it up, but would likely require the need to do the front seat as well to keep the seats lined up. I left it as is. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.