First ride out

[gsx]

First time out after light cosmetic tart up 

[DAZ]

Looks very nice 

[gsx]

Cheers mate , getting a few miles in to bed the clutch in 

[imago]

57 minutes ago, gsx said:

Cheers mate , getting a few miles in to bed the clutch in 

Good job too, I don't think the shed wall could take much more clutch freeing! 

[gsx]

2 minutes ago, imago said:

Good job too, I don't think the shed wall could take much more clutch freeing! 

Bloody thing still dragging with new trac king plates from sps, thinking about changing one of the friction plates for an old one ?

[imago]

1 hour ago, gsx said:

Bloody thing still dragging with new trac king plates from sps, thinking about changing one of the friction plates for an old one ?

I think I'd start with getting some miles on it, bed it in and get a few heat cycles through it then see how it is.

[gsx]

10 minutes ago, imago said:

I think I'd start with getting some miles on it, bed it in and get a few heat cycles through it then see how it is.

Took it apart again just after fitting and noticed one of the steels was tight or awkward fit on the drum so put it at the top , just pulled it out and its not a good fit compared to the others ,don't know why but new one arriving Wednesday. Looks like the efe coming out to play tomorrow 

[imago]

1 minute ago, gsx said:

Took it apart again just after fitting and noticed one of the steels was tight or awkward fit on the drum so put it at the top , just pulled it out and its not a good fit compared to the others ,don't know why but new one arriving Wednesday. Looks like the efe coming out to play tomorrow 

Hopefully you'll get a few hours in before monsoon season continues. 

[gsx]

And wouldn't you know it , efe fired right up but needed clutch bleeding from remote res lol