Slabside engine mounting plates

[Rossco(Iceman Josros)]

Does any have drawings if the hole spacing of the 1100 and 750 engine mounting plates as I’ve been informed that there are differences between them and need to identify what all of mine are .

fanx in advance 

[clivegto]

Which ones you after mate. 

[Rossco(Iceman Josros)]

16 hours ago, clivegto said:

Which ones you after mate. 

I’ve got a bag of them and they are all different so trying to work out which are from what bud 

[clivegto]

1 hour ago, Rossco(Iceman Josros) said:

I’ve got a bag of them and they are all different so trying to work out which are from what bud 

Drew round some 750 ones recently for @GeorgeEI7KOit's on graph paper each big square is 10mm.

Edited March 20, 2022 by clivegto

[GeorgeEI7KO]

52 minutes ago, clivegto said:

Drew round some 750 ones recently for @GeorgeEI7KOit's on graph paper each big square is 10mm.

Fitted an 1127 motor into a 750 frame perfectly. Thanks again. @clivegto

[Rossco(Iceman Josros)]

1 hour ago, clivegto said:

Drew round some 750 ones recently for @GeorgeEI7KOit's on graph paper each big square is 10mm.

Do you have any 1100 ones @clivegto

[clivegto]

3 hours ago, Rossco(Iceman Josros) said:

Do you have any 1100 ones @clivegto

Just a pair of bottom ones although I have some on my 1100.

[clivegto]

Took a front and back Slabby 1100 mounts of my project to measure them bud. Measurements are approximate to centres. O the 1100 ones are steel and the 750 ones are aluminium.     

[Rossco(Iceman Josros)]

Cheers @clivegto I have some steel ones in the box so that explains one question but are all of the 1100 brackets steel ??

[clivegto]

Yes mate, looks like I have a set and a halfway of 1100 ones which are all steel and look standard to me. All my 750 ones are aluminium but think some of the slingshots have a mix. 

[clivegto]

https://accbilletengineering.co.za/wp-content/uploads/2019/08/DSCN8429.jpg

 

These are nice 1100 ones.