Savav2v1 Posted February 1, 2022 Share Posted February 1, 2022 Not sure were to post this... Basically i have a gs1000 with a gsxr wn rear wheel/spindle/brake caliper... With a gsx1100 swinger Hopefully you can see by the pic the spindle shank just sits on the swing arm by about 5mm then the threads start.. The time the nut is torqued theres about 1 thead showing It would be nice to have the shank pass through the swing arm so the chain adjuster clamp pulls on the shank both sides and have enough threads pass the nut to get an R pin fitted... Hope this makes sence Spindle diameter 20mm....shank length from inner face of flange is 29cm...theads are 2.5cm... Would anyone know of a slightly longer spindle about 34cm long Thank you for your valuable time 1 Quote Link to comment
Joseph Posted February 8, 2022 Share Posted February 8, 2022 Why aren't you using the GSX 1100 spindle that matches the arm ? It's 20mm diameter same as the GSXR isn't it not ? 1 Quote Link to comment
Savav2v1 Posted February 9, 2022 Author Share Posted February 9, 2022 Seems like I'm lacking some basic common sence... Thanks for pointing this numbty in the right direction 1 Quote Link to comment
Joseph Posted February 9, 2022 Share Posted February 9, 2022 (edited) Just fyi measured the one i have it's 32cm from shoulder to end of thread Edited February 9, 2022 by Joseph Quote Link to comment
Savav2v1 Posted February 9, 2022 Author Share Posted February 9, 2022 Much apriciated.. the extra 5mm should do it Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.