Gsx 750/katana swing arm bearings

[Kp93]

Does anybody know what bearings I can use to make my gsx1100 katana swinging arm fit my gsx 750? Please, all help is greatly appreciated! 

[wraith]

Pop this in air cooled section you may get a better response 

Can't help with bearings but seem like it's done quite a lot so some one will be able to help.

[TonyGee]

i think most people get top hat spacers made up. 

[Kp93]

I'll try that wraith thanks! And okay Tony, would you know where I could get some fabricated? 

[TonyGee]

53 minutes ago, Kp93 said:

I'll try that wraith thanks! And okay Tony, would you know where I could get some fabricated? 

do you know anyone who works in a machine shop ?   when i put a bandit 1200 swinger in my 750ET i bought an ally tube of the bay of E. it needed to have an O.D of 20mm and an I.D of 14mm,  it fitted really snug and worked perfect after i cut it down to the right length.  i think you will need an O.D of 16mm and an I.D of 14mm. 

i think it only cost about 8 quid. 

Edited June 15, 2021 by TonyGee

[Kp93]

I'll have a look Tony, I need new bearings too so might be able to make it fit like a new un thanks for the help 

[Hippy161]

Check the diameter of the spindle and the outer bearing size in swinger. That gives you 2 of the three measurements that you need. Then look on Eblag to see what is available. The swinger on one of my bikes has 3 needle rollers and 1 ball race. Got the lot for less than 20 quid on Eblag.