Kp93 Posted June 15, 2021 Posted June 15, 2021 Does anybody know what bearings I can use to make my gsx1100 katana swinging arm fit my gsx 750? Please, all help is greatly appreciated! Quote
wraith Posted June 15, 2021 Posted June 15, 2021 Pop this in air cooled section you may get a better response Can't help with bearings but seem like it's done quite a lot so some one will be able to help. Quote
TonyGee Posted June 15, 2021 Posted June 15, 2021 i think most people get top hat spacers made up. Quote
Kp93 Posted June 15, 2021 Author Posted June 15, 2021 I'll try that wraith thanks! And okay Tony, would you know where I could get some fabricated? Quote
TonyGee Posted June 15, 2021 Posted June 15, 2021 (edited) 53 minutes ago, Kp93 said: I'll try that wraith thanks! And okay Tony, would you know where I could get some fabricated? do you know anyone who works in a machine shop ? when i put a bandit 1200 swinger in my 750ET i bought an ally tube of the bay of E. it needed to have an O.D of 20mm and an I.D of 14mm, it fitted really snug and worked perfect after i cut it down to the right length. i think you will need an O.D of 16mm and an I.D of 14mm. i think it only cost about 8 quid. Edited June 15, 2021 by TonyGee Quote
Kp93 Posted June 16, 2021 Author Posted June 16, 2021 I'll have a look Tony, I need new bearings too so might be able to make it fit like a new un thanks for the help Quote
Hippy161 Posted June 19, 2021 Posted June 19, 2021 Check the diameter of the spindle and the outer bearing size in swinger. That gives you 2 of the three measurements that you need. Then look on Eblag to see what is available. The swinger on one of my bikes has 3 needle rollers and 1 ball race. Got the lot for less than 20 quid on Eblag. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.