rerb Posted April 20, 2021 Posted April 20, 2021 Torquing down the clutch nut on my bandit 1200 with the ebc handle and suddenly both my hands were on the bench and my knuckle was bleeding all over the place. Pretty sure this break in the tool slot caused it, is it fine to run or is the very small amount of missing weight going to screw with the engine while it's running? thanks. Quote
Gixer1460 Posted April 21, 2021 Posted April 21, 2021 Against the whole mass of the clutch, that little piece missing will make knob all difference! Holding tools such as this type are best used with two pairs of hands - as you now know! Quote
rerb Posted April 21, 2021 Author Posted April 21, 2021 6 hours ago, Gixer1460 said: Against the whole mass of the clutch, that little piece missing will make knob all difference! Holding tools such as this type are best used with two pairs of hands - as you now know! No kidding, good to know, thanks Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.