Inazuma 1200 front end to 1100 ET

[gsx1100e]

Hi,

Just got good gsx 1200 inazuma front end to my -81 1100 ET, steering stem was loose 20mm shorter than original inazuma´s other than that good condition.

Has anyone installed these to ET´s, simple solution for bearings would ge great.

[stockcar]

Its basically a Bandit frame so would imagine it will be a similar cure but not my speciality I'm afraid.......

[gsx1100e]

22 hours ago, stockcar said:

Its basically a Bandit frame so would imagine it will be a similar cure but not my speciality I'm afraid.......

Now I´m interested tell me more... Whats cure when fitting bandit forks to ET?

[stockcar]

From mmeory people have simply swapped the ET stem into the Bandit / Inazuma yokes and then its std ET bearings

[Toecutter]

Bandit stem into et frame-you can use the stem/yokes from the bandit but requires shortening by 25mm as longer than the et setup. you've got 5mm to play with. Could be a straight swap if you can take up the 5mm with a spacer? Job done. Bearings are the same from memory...Was seven years or so ago when I popped a set of B12 forks in mine so casting my mind back... ET stems are welded into the yokes so requires chopping about. Or at least my 750 ones were. B12's just press out.

Edited May 18, 2018 by Toecutter

[gsx1100e]

Ok so maybe stem I got whit front end is not from inazuma it came whit bigger diameter ball bearings. Mayby from busa, since seller svapped busa front end to inazuma.

I will use et stem, it is not welded