Hi, couple of questions for the modders on here

[Joebloggs]

Throwing a GSX750 ES together from parts I already have and those that can be found cheap on Eblag , I had a low mileage oil cooled lump sitting in the shed and managed to get a full set of bodywork, frame and some bits and piece's for a couple of hundred quid so I'm now looking at front and rear ends. 

I know from previous experience that many parts are interchangeable but I'm struggling with the following

Will a 600/750 GSXF front yoke bolt straight in? If so can I use a bandit 600 top yoke (spacing/offset?) which will allow me to fit conventional handle bars?

Late model 750f swing arm pivot tube dimensions and length of arm from center of swing arm spindle to center of wheel spindle with the wheel at its most forward point (if you get what I mean)

Looking to use the 750F arm as hopefully it will be a plug in and play item ( Sprocket alignment etc)

I'm not concerned about the shock as I'll be converting it to twin shock (unless someone gives me a reason why I shouldn't)

Any info greatly appreciated

Joe

 

 

[Swirl]

Wi probably have a full 750f front and rear end for sale shortly

[Joebloggs]

1 minute ago, Swirl said:

Wi probably have a full 750f front and rear end for sale shortly

Got a set of forks off Eblag today (750) and a rear wheel, just wondering if I can use the 600 yokes simply because I prefer the handle bar's on the 6 (still not great but better than the 750 set up)