Stanman Posted December 9 Posted December 9 Hello folks, I have just picked up an old GS engine, is there an easy way to identify what size it is? It's chain driven I took the carbs off and the O/D of the carbs is 34mm (engine side). The engine number is very warn and does not look right. Are there any other ways before I start to strip it down for a rebuild? Quote
Gixer1460 Posted December 9 Posted December 9 Capacity should be cast on a plaque on rear of the cylinder block - usually LHS. 1 Quote
Stanman Posted December 9 Author Posted December 9 1 minute ago, Gixer1460 said: Capacity should be cast on a plaque on rear of the cylinder block - usually LHS. I did look but didn't see anything, I will check again tomorrow Quote
BigT Posted December 10 Posted December 10 The capacity is on the front left of the motor, in a rectangle That's a 77-79 motor Quote
Stanman Posted Saturday at 06:55 PM Author Posted Saturday at 06:55 PM On 12/10/2024 at 3:16 AM, BigT said: The capacity is on the front left of the motor, in a rectangle That's a 77-79 motor Nice one, I will have a look. Quote
ccroaker Posted Saturday at 10:53 PM Posted Saturday at 10:53 PM stamped on the front left as you sit on the bike cylinder just above left exhaust header Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.