berty Posted December 9, 2019 Share Posted December 9, 2019 hi all . Dyna s install cylinders 1 and 4 timing marks clear on plate Vertical line then T , Vertical line then F , 1.4 then vertical line. | T | F 1.4 | static timing onto vertical line next to F done however - marks for cylinders 2 and 3 - only marks on back plate are one vertical line followed by 2.3 with no other vertical lines | 2.3 Dyna s unit came with modules undone, and want to get cylinders 2/3 firing time correct. Any pointers? Quote Link to comment
Gixer1460 Posted December 9, 2019 Share Posted December 9, 2019 If you connect it all up as std., run it and check the timing with a strobe on #1 lead. Then swap the dyna wires blue & white for each other then swap plug leads 1/4 and 2/3, run again and the strobe 0n #3 will use the 1/4 marks checked first time but will apply to the 2/3 trigger which can now be adjusted to get the line matched. I've never tried this and take no responsibility etc - I just eyeballed settings on mine and never pushed the timing limits to be worried about +/- 2 degrees or so! Quote Link to comment
berty Posted December 11, 2019 Author Share Posted December 11, 2019 Will head scratch . cheers Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.