B12 wiring harness

[Glenny86]

Hi there I am in the middle of wiring up a slingshot with a b12 engine and I was just wondering if people are wiring the throttle position sensor in on just not bothering. Cheers

[Bow]

Chop it out,  it’s junk.   This might be of some use to you .

removes all the junk not needed,  sidestand switch, clutch switch,  diode and relay,  plus TPS. Don’t forget to use a resistor on the ignition control unit.

 

ive ommited the light wiring,  but easy to add from the fuse box.

[Glenny86]

20 hours ago, Bow said:

Chop it out,  it’s junk.   This might be of some use to you .

removes all the junk not needed,  sidestand switch, clutch switch,  diode and relay,  plus TPS. Don’t forget to use a resistor on the ignition control unit.

 

ive ommited the light wiring,  but easy to add from the fuse box.

Cheers that a big help. Do I ne a resistor tho if I am using a b12 ignition switch

20 hours ago, Bow said:

Chop it out,  it’s junk.   This might be of some use to you .

removes all the junk not needed,  sidestand switch, clutch switch,  diode and relay,  plus TPS. Don’t forget to use a resistor on the ignition control unit.

 

ive ommited the light wiring,  but easy to add from the fuse box.

 

[Bow]

Only if your using a B12 ignition control unit.  

Orange/Red from the ICU to a 100ohm resistor then to earth.  

That way, you can use any ignition switch you want.  Same diagram can be used for a Dyna 2000 set up. Just won’t need a resistor