XzoB12

Would the intake rubbers from the 86 gsxr1100 be the correct ones ? Or should I round up some newer from a mk1 ? Thx for feedback….

Got a chance to get a set of Rs38’s on the cheap side got a 2002 gsf1200 with pipe and pods RU2922 and 4* Advance.. will 38 be alright or the 36s be better?? TIA….

Thx Gixer1460 , found the 2920 on Amazon for 89.00 delivered Tomorrow !!! Thx

Got a 2002 B12s , will the KN Ru2922 work or what is another number for 01-05 B12…TIA..

If your running a 4 into 1 install an o2 bung in the collector inline with more than likely #1 high and tight to engine and you’ll be able to dial in every circuit in those bad boys.. shoot for 12.8 -13.5 on idle circuit Then set the main as close to 13.0 without detonation if detonation is experienced throw more fuel down to 11.5 , then play with needle to get the crispness throughout the entire range . I’m in the beginning stages of doing the same thing with stage 3 Dynojet kit on my 02 Bandit 1200s , but with the stock BSR36ss….takes the guessing out of it without Dyno time..

Thx guys , found a bad ground and starter solenoid going bad…Thx agian

Got an 02 with the 36’s , going to install a K&N and FreeFow exhaust. Has 15 pilots ,100 mains , I want to shim the slides as well. My questions are how much more pilot would be needed , if any, and Size of main jet to start off with. And how large are the shims..TIA…

Thx , will give that a look…✌️

Got 13.4 sitting 14.1-3 charging(running)…it seems to have something to do with neutral switch , about a minute before it dies the neutral light goes out starter button dead . Got a starter solenoid coming .

Got a New to me 2002 Bandit 1200s. 4000 original miles Beautiful Blue . Rebuilt the carbs Al Balls kits , working perfectly ,revving, idle good , 10 minutes into running , dies and starter button won’t engage,nothing . All lights working . Wait 30 or so minutes , starts right up . Repeat,Repeat…….TIA..