Highwaystar

Got one on mine, polish up real nice

Anyone had issues with the gasket leaking from the sender ? Mine has just started leaking but not all the time ? which is baffling some days nothing and then a small amount . recently topped tank full with super unleaded and millers storage additive added. . Issue seems to have started after this. I will order a new gasket. It was just the issue of the random leak i thought someone might have explanation for. I have I have been told random leak at iffy gasket probably caused by temperature/ tank expansion.

Got through to NRP via email ,don't think they bother answering phone! Anyways they had the T piece in and link pipes £60 posted. I think they are keyster items too .

Found a site in uk called nrp-carbs which shows them available, but can't get them on phone which always raises my suspicion

Just tried thanks, no joy

Meany to add. Meant to add , for 78 1000 with mikuni carbs

Anyone know where you can get these Fuel inlet T pieces in the UK.

Using standard master which us pretty dire ! I Just made the caliper adjustment purely to look better. I have a gsxr nissin master cylinder on the front pared up to a twin pot SV tokico

Will post some tomorrow, I also had to extend the head light bracket to have light fit flush in fairing.

Quality stuff

Thanks, bit disappointed the pictures have transferred over poor quality.

My take on a cooley replica using my GS1000C. Decided to keep the single disc but upgraded with larger diameter modern disc SV twin pot caliper and gsxr master cylinder. Lots of other mods, only requiring bracket for brake resovoir to finish and bleed brakes through.

On this subject I decided to stay with the original caliper but trim away all access metal to stream line it. Also did same with bracket

That looks ace, like the bike too

Thanks, lots of info to go on here

Thanks, that's underslung which is route I may need to go. Still trawling the Web for a top/standard fitting caliper. Seen one off a Gs500e that may be smaller but hard to tell.

Going to be checking bracket and disc pcd/bolt spacing later today. I've done a lot of research to see if there is a non underslung smaller caliper that looks compatible and has the lug to attach the torque arm, but only stuff I can find looks just as big as this lump.

Ah yea !

That looks smart, just a bit suspect of model fittment as it says gsx1000 !? I'll send them an email

Thanks,,I will look into it

I will post some pics soon, I hope to have new paintwork back next week, also front brake upgrade ready to fit.

OK thanks, firstly I'd better measure spindle size then go from there. I have friends that can assist reference lathe and spacers etc. So for example do you think I say I got a gsxr750 srad complete rear brake, it could be possible to fit with some work.

Wanting to change the huge rear caliper for something smaller like the brembo picture attached, appreciate I may require a different bracket and disc. Just wondered if anyone had done this .Also consider underslung caliper but unsure how this possible without torque arm.

Pleased with the fastec fork brace. For reference it would have required my standard mudguard to have had the bolt holes elongated a few mil as it was sitting to high for brace to fit (think my guard may be a pattern part though) no such problem with the fiberglass guard.