Ole
-
Posts
15 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Posts posted by Ole
-
-
Hey folks
I can get a set of Bs 32 carbs very cheap. it`s from a 86 GS 850 Will they fit a 82 GSX 750 Jets etc The 750 is with pods and 4 into 1
BR Ole
-
Thanks for the replays
-
Thanks for the replays
-
I got hold off an 83 Gsx 1100E from Germany. It have not run in at least 5 or 6 years, and the carbs was stuck and dirty. I took a set off BS34 from a GS 1000 , put in the main jets from the old carb, and put it on along with a set of pod filters. The engine started fine but would only rev to about 5k As far as i remember there was a hp limit i Germany back in the days and the main jet in the carbs where only 107,5 What size do they have in the unlimited version?
- 2
-
I think you're right, Wiseco it is, must have measured it wrong. now i get 73mm. I have put a picture off another set i have, branded with the W, but this set have numbers on the top. By the way this is where i am with engine, see pic I have ordered new oilseals for crank and transmission and new bearings for the clutch. Anything else i should pay attention too?
-
-
The RS 34`s goes with the inlets from 34cv carbs. Done that back in 88
- 2
-
-
-
Thanks for the replays. I think i will try to use the parts and build a modified engine.I have a nice running GS 1000 so i have plenty off time too work on the second engine. I have a newer CV head. Is there any advantages off using that (bigger ports) and is it possible to get carb to head rubber that will fit with the 29 Mikunis? Is the Yoshi cams plug and play or do i have to make any conversion with valves/buckets?
- 3
-
Hi folks
I have recently bought three GS 1000 engenes, two in boxes and one assampled, mostly because it is always nice too have some spareparts on the shelf.
When i took a closer look at the parts i found a pair off Camshafts markt "Pupy" Is this the Youshimura camshafts? I also found a set off Mikuni carbs which i think is the VM 29 Smootbores. There where also a set off pistons and a matching barrel. I roughly messured them at 73 or 73,5 mm Can anyone tell mee what make these pistons are. I`ll put some fotos here and i hope you folks here at OSS can help with some answers. I hope you can read my english.
Best Regard Ole
- 2
-
-
BS 32 Mikuni
in Air Cooled
Posted
Thanks Wraith