[Bandit 02 600 electrics]

58 minutes ago, TonyGee said:

yes it is under the engine cover. 

Ok, think I’m on about something different but no worries can you help with any of the other stuff

[Bandit 02 600 electrics]

I have one on the side of the carbs too

[Bandit 02 600 electrics]

3 minutes ago, TonyGee said:

its the coil that lives under the right engine cover, it sends an ignition signal to the CDI. 

Mine is not under the engine cover it’s a black disc above the carbs 

[Bandit 02 600 electrics]

Hi peeps,

im going to fit munit blue to my bandit,few things I’m unsure of. my ignition  black box has tach/two wires for neutral and two which are signal two run to pulse generator (what is that? ) neutral switch has blue wire which goes to a diode then up to the dash light also on the neutral switch red/black from ignition unit a green/blue which goes back to the ignition unit and black/white which I think is the earth also do the oil , neutral fuel switches get power from at the dash ? I’m going to use a Koso DL-03SR  I have drawn out a wiring diagram which I’ve attached does it look ok 

 

many thanks 

[M unit blue]

Thanks bud,

im not sure what loom wiring I need to keep and what to cut off wiring is not one of my best thing 

[M unit blue]

Yeh don’t mind re wire just not sure what wires I’m going to need and what to cut out 

[M unit blue]

1 hour ago, Joseph said:

Don't you need to feed 12V from the battery into the unit then pull the wires to each item from there ?

It's a total rewire from what i've seen of them.

That said I have never used them because i don't see the point of them, seeing how simple the factory system is

You'll need to retain the ECU of course and I suppose the starter relay ?

I can help you out if you can get the instructions to me. Wiring bikes and electricity is one of the rare things i'm good at

Sent you a pm buddy 

thanks 

Kev 

[M unit blue]

Thanks for your input bud 

so I have to leave wiring old loom in place and run new wiring? 

[M unit blue]

Good afternoon peeps,

im about to embark on wiring up an m unit blue  on my 2003 600 bandit I’m not 100 % with wiring I can’t seem to get my head round it do I take all the wiring loom out then there’s the cdi do I use all the wiring from it? Would really appreciate it if you could help me 

Picture is off the bike work in progress and wiring diagram plus one to supply power to the cdi 

thanks 

Kev