[Subframes]

1 hour ago, Hanma-shin said:

Go look in the projects section.

Could find anything mate 

[Subframes]

Hi guys has anyone welded a subframe to the bandit frame thats narrower than the bandit frame looking for the best ideas to get in welded up strong enough to still go two up if anyone has pictures that would be great 

FYI its a zx6r 2011 subframe going on the bandit frame 

Presuming the likes of the gsxr later subframes will have had the same issues 

[K7 gsxr Swingarm set up in a slingshot 1100 k frame]

25 minutes ago, MeanBean49 said:

5mm off wheel/carrier and spacer to make carrier sit 5mm closer to wheel centre

Also did you have to trim the rubbers ? 

[K7 gsxr Swingarm set up in a slingshot 1100 k frame]

22 minutes ago, MeanBean49 said:

5mm off wheel/carrier and spacer to make carrier sit 5mm closer to wheel centre

Brilliant thank you mate how did you know how much to take off mine is b12 with k7 1000 swing arm

[K7 gsxr Swingarm set up in a slingshot 1100 k frame]

On 11/14/2018 at 10:35 PM, MeanBean49 said:

I put a k7 arm in a huc frame, they are designed to take slingshot running gear.

All i had to do was make some top hat spacers to sleeve the spindle size down and make up the width difference, k7 was narrower.

Also had to make some adjustable dog bones because mount is on the underside not the top.

I used standard slingy linkage and wheel.

Not sure on k7 wheels but earlier k series gsxrs ones are 110mm sprocket offset and slingshot are 100mm from centre of the wheel. Takes some sorting out, front sprocket spacing, hub/carrier machining if you want to do the job properly

How much did you machine the carrier and or spacers ? 

[K7 gsxr Swingarm set up in a slingshot 1100 k frame]

Meanbean47  how much did you machine of the sprocket carrier and did you have to trim the spacer ? I am in the middle of doing this as well hope you get this cheers