[B12 and other 5,5" wheels]

I have a 5.5 wheel from a gsx-r 1100 in my bandit arm.  A 2003 model of I am not mistaken.  Used the gs sprocket carrier and had to make 2 new spacers.

[GSX1100ES inlet rubbers?]

Radiator hose perhaps.

[et flywheel alternatives]

20 hours ago, Fazz711 said:

You could do the cut on a lathe and then lap by hand with a little fine grinding paste 

That could work

[et flywheel alternatives]

I have seen a precision technique for setting cross slide angle and was thinking I would slso do test fits and bluing before I get to full depth of cut to confirm the the fit.  A tool post grinder would be nice, maybe I can build on easy enough.

[et flywheel alternatives]

I have picked up the parts for this and am going to attempt to cut the rotor for a large taper using my new (1950's) lathe.  Wish me luck.  I will post back with my results.

[Welded starter clutch]

I have a gs1100 that I have bored out to 1395 and it has been suggested that I weld my starter clutch.  Does anyone here have experience doing this?  If so do you have a picture or description of where to weld that you could share?  I am sure I could figure it out on my own but prefer to follow a proven method.  Thanks