Sheep Posted November 21, 2018 Share Posted November 21, 2018 (edited) Guys, In process of fabricating another set of downpipes for the EFE and I was wondering whether I should fit a link between #2 & #3 tubes while I am at it.If I am correct in thinking that a link helps the balance of flow or something like that I am thinking this time around I am going 4 into 2 with cans either side of the bike. Edited November 21, 2018 by Sheep Quote Link to comment
Gixer1460 Posted November 22, 2018 Share Posted November 22, 2018 Doesn't do jack! Some have tried 'resonators' between 1&2 and 3&4 but more marketing tool than performance enhancement! As 2 and 3 fire adjacent - you'd 'unbalance' flow from 1 and 4 for no gain. Quote Link to comment
wraith Posted November 22, 2018 Share Posted November 22, 2018 More work for no gain. you see a link pipe on standard 4-2 zorsts between the two single pipes after the four down pipes, wether it dose anything? You will find, there will be some on here that say as you're making your own zorst you will only make the bike run badly I say if you can make your own zorst for your bike and it looks good and the bike runs, good on you and instead of spending £££ on a zorst just buy a sticker for £0.99 1 Quote Link to comment
Sheep Posted November 22, 2018 Author Share Posted November 22, 2018 Ok that makes it easier then.One less bit to worry about.Cheers guys. 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.