Jump to content

Probably a stupid question....


Mak595

Recommended Posts

The stud spacing is the same, but the cylinder sleeves would probably not fit into the 750 bottom end (without machining). The 1100 cylinder block will need maching too to the shorten it to suit the shorter 750 studs and shorter 750 stroke.. I believe the wrist pins 750 and (early) 1100 are both 18mm.

Fitting an 1100 engine in your 750 seems like less work.

Link to comment
11 hours ago, arnout said:

The stud spacing is the same, but the cylinder sleeves would probably not fit into the 750 bottom end (without machining). The 1100 cylinder block will need maching too to the shorten it to suit the shorter 750 studs and shorter 750 stroke.. I believe the wrist pins 750 and (early) 1100 are both 18mm.

Fitting an 1100 engine in your 750 seems like less work.

Yep, certainly sounds like it !!

 

There's a 1100 block on Eblag minus the head, would the 750 head fit?

 

Thanks

Link to comment
12 hours ago, Mak595 said:

There's a 1100 block on Eblag minus the head, would the 750 head fit?

I think it would. Smaller valves and ports.

As I've got both 750 and 1100 top halves on the shelve in my kitchen workshop I might be able to do further comparisons, but as it far to hot right now to be lifting anything heavy and first move all the stuff stacked in front, I'd rather not.

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...