Concentric swingarm adjuster swap

[dynodave]

Does anyone know if you can get hold of weld in billet straight rear axle adjusters to replace the concentric ones in a JMC braced aluminium swingarm?

[Tony Nitrous]

34 minutes ago, dynodave said:

Does anyone know if you can get hold of weld in billet straight rear axle adjusters to replace the concentric ones in a JMC braced aluminium swingarm?

It was a while back but I went the same way. Ended up with JMC chopping my concentric’s off and welding on 6” drag adjusters.  I’m not sure who’d be best to do it now but it’s certainly no big drama. 

 

Edited April 24, 2023 by Tony Nitrous

[Dezza]

Spondon GIA will do this sort of job.

[rodneya]

Matmachex Swingarms will probably di it too

[Duckndive]

Depends where in the UK you are ? may be someone close by 

[dynodave]

Nottingham

[Duckndive]

GIA then only down the road 

[Dezza]

17 hours ago, Duckndive said:

GIA then only down the road 

 

17 hours ago, dynodave said:

Nottingham

Last time I was there (last September) they had a big pile of chain adjuster blocks pre-fabricated for their own swinging arms and for modifiying units brought to them. They have a lot of work on at the moment because I called yesterday about a small job and was asked specifically to bring it in next week whereas usually it's 'just bring it over when you feel like it.'

[dynodave]

Cheers for the info, I'll pass that on to my mate