Rubbers

[Big-D]

The carb rubber... The rubber that secures the carb to the head, has snapped on my engine. What others are a direct replacement and from where? It's the outside left cylinder as sitting on the bike 

engine is gsf1200 

[fatblokeonbandit]

Get a new one, only £33 less OSS discount from robinsons.. but if ones perished and snapped!!! what are the rest like, 

13101-40C00

INTAKE PIPE NO 1 (ITEM 25 COMES WITH THIS)

To Order

£33.40

 

http://www.discountbikespares.co.uk/ourshop/prod_1920510-PIPE-INTAKE-RUBBER-NO-1-GSF1200-GSXR1100.html

 

 

http://www.cmsnl.com/products/pipe-intake-no1_1310140c00/#.VmnNPvmLSUk

 

 

[Captain Chaos]

Mk1 and Mk2 B12's have different carb rubbers, make sure you order the correct one

[Jaydee]

Mk1 and Mk2 B12's have different carb rubbers, make sure you order the correct one

I've always heard that mk. 1 and 2 rubbers were non-compatible. Putting together a mk.1 b12 at the mo. It came with mk.2 carbs fitted. I had a set of mk.1 carbs to replace them. I know now I should have taken a pic of a set of Mk. 1 and 2 carbs inlet to inlet as there's roughly only 3mm of a difference between spacing. A bit of a warm up with a hairdryer to soften the manifolds and I don't think it matters if you use mk.1 rubbers on mk.2 carbs and vice-versa. The carbs will pop right on. 

[Big-D]

Cheers fatbloke, the rubber hasn't perished just snapped in transit with something leaning on the carb 

[Captain Chaos]

 A bit of a warm up with a hairdryer to soften the manifolds and I don't think it matters if you use mk.1 rubbers on mk.2 carbs and vice-versa. The carbs will pop right on. 

and they will pop right off again with the slightest pressure.

Been there done that etc