Jump to content

newbie with a efi setup question


Recommended Posts

  • 2 weeks later...

So today I pulled the starter clutch off boy what a mess everything is worn out  as you see its  messed up  going to replace everything and I will have to dress the crank  to get the built up material of of it I can scrap it of with a razor knife  and to think I  thought I messed it up and to find out its been like this for a while . I had to use a puller to get the drive gear off   didn't take much to get it off but i could mot pull it off by hand oh and the stator was loose the three screws that hold it hand come loose. So loose in fact one screw fell out when I pulled the cover off . and one last thing how do I decode the engine number its got a gs1100x-118290 on the case thank you all for the input

20200927_163133.jpg

20200927_163144.jpg

20200927_165757.jpg

20200927_170802.jpg

20200927_170855.jpg

Link to post

That isn't bad - stop being a girl! Just clean the starter clutch in some petrol / brake cleaner, check the screws fixing it to the rotor and CAREFULLY dress the galling on the crank taper and int. rotor diameter with wet & dry paper, then lap with valve grinding paste - job done. Don't touch the ground surface where the starter clutch rollers run!

  • Like 1
Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...