Jump to content

Injectors dimension


Recommended Posts

16 minutes ago, Goo'Roo said:

Mmh, i thought they could be enough.

Engine is a 1216 with ported M head and M cams, chargecooler and a pretty big turbocharger. I'm looking for a efr 6758, but the price at the moment is slowing everything down.

Silly money...

Link to post
  • 2 weeks later...
On 9/18/2019 at 8:28 PM, manden said:

Look at the siemens deka 5 injectors. Low latency and dead time. Developed for turboed motorcycles and fair priced at around 70$ each flowmatched and new. The one I've used is 800cc at 3bar. I don't know if there is other sizes.

Do you have a link or a code? Just to understand the injector family and if they're suitable for my application

Link to post
  • 2 weeks later...


I think that they're perfect for my application. Very very compact


Coil Resistance: 12.5 Ohms / High Impedance / High-Z (No ECM driver modifications required)

Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 60 lb/hr = 630 cc/min = 453 g/min

Static Flow Rate @ 87PSI ( 600kPa ) w/Gas: 85.7 lb/hr = 900 cc/min = 648 g/min

Gain: 0.11ms/mg Offset: 0.055ms

Turn on time @ 14VDC: 1.14ms

Turn off time: 0.85ms @ 600KPa

Connector: Minitimer EV1

Series: DEKA 4 ( DEKA IV ) Orifice

Type: Multi-orifice Spray Pattern: 30 Degree Spray Cone

Factory fitted with Viton upper and lower o-rings 37.5mm end to end, 14mm oring


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...