harris magnum 2 katana 1100 motor

[busa ash]

Spoke with yoshi johnny and did a deal on his project  ,

lots ask about special frames and want them , but dont commit to buy when they see them ,

if only it was cheaper ? nearer ? can we do mates rates ?,

  NO CASH , this is a good build and with just the right amount of cool 

pics later 

[baldrick]

Havnt you got enough harrises lol. 

lets see the pics, is it the blue and silver one, with the guage in the tank?

[busa ash]

Here we go then 

[busa ash]

[busa ash]

I have bought a swingarm from a clive via swirl s original green harris  Gurls blouse nc29 full arm 

[busa ash]

The bit I hate the most wiring 

[SiBag]

Is that a Mag-II or a Mag-I ?

Tank is def a Mag-I

[busa ash]

magnum 2 with magnum 1 tank si 

8 hours ago, SiBag said:

Is that a Mag-II or a Mag-I ?

Tank is def a Mag-I

 

Edited August 12, 2019 by busa ash

[busa ash]

Been to my mates house to have a play on his old milling machine

Rsv mille rear brake set up I am trying to use with gsxr disc and saxon wheel , tyre too wide it's a 190  bit tight and will need to have z proper look in the daylight 

[busa ash]

Mirrors from a long lost project 

[busa ash]

Fairing looking for a headlight with side light for mot

[busa ash]

Slabby rear light for the harris seat unit 

[busa ash]

Seat pad may be redone but for now it gives the right look

[caferacerdan]

side lights arent a requirement for an MOT. only need low and main. believe the vfr or cbr400 headlights have low and high built in

[clivegto]

Can you put a notch in the arm with a slightly smaller tyre as well Ash.

Edited August 15, 2019 by clivegto

[busa ash]

Just found a 20mm axle think it's a yamaha one but it's better than the zooki one I was going to use 

[busa ash]

Wiring and more wiring 

[busa ash]

Found a spindle for the rear swingarm think it's from the front of a yam 20mm  

[busa ash]

Well a really good day yesterday loom all connected and tested . Routed just need too loom tape it now .

 

Also ordered the oil fittings for the take off point behind the motor 

[busa ash]

Ta d dah arrived this morning 

[busa ash]

Bit of time working on bike ..

Soooooo the foow king thing wont fit one fitting too close to crankcase and other smack bang in middle of clutch cable route 

[busa ash]

[Dezza]

Switch to large banjo fittings?

[busa ash]

The saga continues lol sent 2x 90 degree fittings 

[busa ash]

First fitting hits second fitting ffs so ordered an 8 to an8 coupler see if that works