Micron Exhaust header spigots - make new ones?

[robbo_64]

I've got a 750 Slabside Micron full exhaust system in my possession but the header spigots and spring plates are in poor condition. 

Not expecting anyone to have any spare originals, but is there anyone on here who could make a set of spigots that I could get welded into the header ends? I could just use standard type exhaust flanges with them then, I guess?

Thanks

[Foz]

Last time I needed some I chopped the spigots off the centre two pipes on a b12 system fortunately I had two scrap systems

[robbo_64]

On ‎4‎/‎19‎/‎2019 at 6:49 PM, Foz said:

Last time I needed some I chopped the spigots off the centre two pipes on a b12 system fortunately I had two scrap systems

Thanks Foz but I need all 4 I'm afraid....

[Lachie04]

Don't know if this idea is any use to you might be a bit too much work , depends on how desperate you are

I got some of these off the bay

38MM 1.5" OD Sanitary Weld on Ferrule FitsTri Clamp 1.5" Stainless Steel 304 S3

Then had a mate turn out/rebate the inside to the size I needed added welded additional material to the outside where it fits against the exhaust gasket To use the  original flanges.

Enlarged the flange to 38mm also

Then welded the pipe in

 

 

Edited April 24, 2019 by Lachie04

[robbo_64]

On ‎4‎/‎24‎/‎2019 at 10:50 AM, Lachie04 said:

Don't know if this idea is any use to you might be a bit too much work , depends on how desperate you are

I got some of these off the bay

38MM 1.5" OD Sanitary Weld on Ferrule FitsTri Clamp 1.5" Stainless Steel 304 S3

Then had a mate turn out/rebate the inside to the size I needed added welded additional material to the outside where it fits against the exhaust gasket To use the  original flanges.

Enlarged the flange to 38mm also

Then welded the pipe in

 

 

Thanks Lachie04