VJ Posted February 12, 2019 Share Posted February 12, 2019 Making progress on my gsxg engine rebuild but I cant get the clutch centre nut out, I welded some bar onto a steel plate to try and make a holding tool but all it did was bend the plate. Any amazing tips to get it out without needing to buy the proper tool? Cheers John Quote Link to comment
Jaydee Posted February 12, 2019 Share Posted February 12, 2019 I use an air impact gun to strip out clutches. Saves a lot of time. Quote Link to comment
Guest YoshiJohnny Posted February 12, 2019 Share Posted February 12, 2019 you did unbend the lock washer??? Quote Link to comment
davecara Posted February 12, 2019 Share Posted February 12, 2019 It takes exactly 4 dugga duggas to get that nut off 3 Quote Link to comment
jonny1bump Posted February 12, 2019 Share Posted February 12, 2019 I use impact gun too. If your talking M clutch and undoing big nut that holds the conical springs against pressure plate, then get two pieces of decent steel. Join together one end with long bolt into swing arm pivot and at oposite ends bolt in each arm that lines up with the slots in the outer pressure plate. Hope that makes sense, can take picture tomorrow night if you don't understand that ramble. If you on about inner basket so clutch already out long bar attached to old clutch steels with spacers. Quote Link to comment
Gixer1460 Posted February 13, 2019 Share Posted February 13, 2019 19 hours ago, davecara said: It takes exactly 4 dugga duggas to get that nut off Beautifully Descriptive.............................although is that big or small Dugga's? Quote Link to comment
davecara Posted February 13, 2019 Share Posted February 13, 2019 (edited) Start with a little one, one big, one small and then a big finish Edited February 13, 2019 by davecara Quote Link to comment
CockneyRick Posted February 13, 2019 Share Posted February 13, 2019 Kick & swear at it. It'll soon give up Quote Link to comment
Blubber Posted February 13, 2019 Share Posted February 13, 2019 6 hours ago, CockneyRick said: Kick & swear at it. It'll soon give up Does this also work on exhaust header bolts? 1 Quote Link to comment
CockneyRick Posted February 13, 2019 Share Posted February 13, 2019 Apparently not, 2 days of abuse & it won't give in Quote Link to comment
jonny1bump Posted February 13, 2019 Share Posted February 13, 2019 Pressure plate removal tool. Quote Link to comment
jonny1bump Posted February 13, 2019 Share Posted February 13, 2019 Hub removal tool. Quote Link to comment
VJ Posted February 13, 2019 Author Share Posted February 13, 2019 right, I need a stronger pressure plate tool then or a dugga dugga gun. I'll have another shot in a few days then. Cheers John Quote Link to comment
CockneyRick Posted February 14, 2019 Share Posted February 14, 2019 Got my Pressure plate tool of Eblag, just a modified pair of mole grips Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.