Jump to content

carb identification


wobblegob

Recommended Posts

The ID bore would tend to suggest 36mm OD so not 1100M carbs which would be 40mm OD - but they could have been swapped as 40mm's are a PITA to tune easily. Looks like a DJ needle but its a while since I've seen one! DJ main jets are sized in steps of two - 132, 134, 136 etc and only fit DJ emulsion tubes - threads are different as I remember :/

Link to comment
16 hours ago, Blubber said:

It reads 34.8 mm

Thank you. The 36 was a lazy school boy error....I had it in my head because of a post in this thread. The point 8 however I got wrong, I can see why, I just thought it was lined up on the 0.6. 

So the good news is I remember how to read a vernier. The bad news is I'm capable of getting it wrong!!! 

Edited by wsn03
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...