Search the Community
Showing results for tags 'gs550. shims'.
-
Hi This was my love until 1989 when mortgage interest rates were 18.9 percent so she had to go. Would love to find her again. Please helpIndex was YMD507T Ta
-
Hi. Setting the clearance on the valves is proving to be a pain. Haynes says do it either upright or horizontal (left or right) depending on inlet / exhaust. Okay so I get a reading of 0.09mm, which is too much, 0.03 - 0.08mm is the range. I'm sure I have read go towards the larger gap, but could be wrong. Anyway, how do I get the shim out without removing the cams again? All the gaps vary between 0.03 and 1.04mm I know the size of shims within the engine, and think I can move a couple around to decrease the high reading and increase the low. Where can I get shims at a reasonable price? TIA Andy