Jackzx10

Result thanks

So the original carbs were fooked ..I think I followed a hint on the web that later GSX750F carbs mikuni bst 36 could do the job..so I fitted them and it runs ..good stuff..will be running Ramair filters and it will be going on the dyno for set up. BUT..because the float bowls sit at the wrong angle Im wondering if this might bugger things up ??? Anyone have any experience Thanks for your time

Anyone ever used 1200 Bandit clocks ( digital speedo) on an 80's GSX1100 ? Thanks

Ok so I know its a much worn question but cant seem to get my search right ? Widest rear tyre (17" swap) can go into a standard 83 gsx1100 swingarm and frame THANKS Folks

So I realised I had a Fazer 1000 front end...Quick compare showed the stem bearing diameters are the same..result..Just had to turn down the length of the top bearing diameter..Will have to make up a spacer when I get to test fit ( could be a while original front end still on and lots of other things to get finished

Bike is an 83 gsx1100 I have a 600 bandit front end which I have modded to use Brembo calipers. I know everyone Is using the 1200 forks but other than the extra 2mm diameter the only advantage I can see is preload adjusters ( I can figure that with spring spacers) Anyone think that there is a reason not to go ahead before I swap my stem ? Thanks

Hiya. Can anyone tell me the swingarm pivot width on an 83 gsx1100 twin shock ? Thanks

Will ultimately put it on the local dyno. But first want it to fire up and pull some revs. Could be a while but I will announce all results Thanks

Hi all. I have been over what I think are all the available posts and links but can’t find what I need So… it’s the much talked of Mikuni bst 36mm carbs on a GSX1100. ( 83 in this case) I have a nice set from a 92 GSX 750F ( katana ) What I would like to know are the baseline jet sizes and settings . It has a ‘Mac’ 4-2 exhaust ( anyone want to trade for a 4-1 ?) Stock cams Right now it has a set of RS flat sides on which will be going on another more worthy build and to be honest doesn’t really run as I’d like with them on Anyone care to give me some ballpark sizes etc. Big thanks for your time. John