Is my first time doing a Turbo motorcycle, it was always a dream to own one PS: my English is kind bad so excuse me if i write something wrong
Bought a Bandit 1200S 2000 with 41k miles
I got a Turbo kit for my B12, and some Hayabusa pistons, bought new OEM needles and springs because it had different parts
replaced the gauge for a TFT one
But now comes the worst part... When i got everything installed the return was a little restrictive because i used the breathing tube from the gas tank and gas started to go inside the plenum and inside the turbo, was a huge mess, the floor was full of gas... then i cleaned it up, even cut the tube even shorter
tested the fuel pressure without the gas tank 2psi, then tested again with return connected to the gas tank, 2 psi too.
https://youtu.be/I-AWrZDpkQY
but the motorcycle was still not running well...
then i removed the carburetor and checked the float weight, they were not aligned, so i didn't know how to check the height because the float surface is not flap, so i didn't know how to setup, so i only made the float line parallel with the body, i even used a caliper to make sure that the front and back were at the same height
but the bike still running bad... I'm tired and frustrated, i would really appreciate some help
btw, the oil pump is sideways, is that ok? because even to i let the pump run for a few seconds after i stop, the oil still drips to the floor, and is a very dark oil, i think it is oil with gas, but I'm not 100% sure
Thank you