Jump to content

Peterbertie

Members
  • Posts

    11
  • Joined

  • Last visited

Reputation

2 Neutral

Personal Information

  • Location
    Norwich

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Peterbertie

    TPS

    Does anybody happen to know the settings on 750 Zuma for TPS I have Haynes manual but can't quite get lower range just wondered if Haynes is accurate I can't get mine into the range
  2. So the non runner I brought now runs ticks over nicely hit the throttle and it picks up fine. Sometimes when I after a big hand full shut throttle off she gives of a bang I have noticed No1 downpipe takes longer than the rest to get hot. Carbs stripped cleaned new carb kit installed float height checked valve clearance done at a garage by previous owner in February it has a yosihimura exhaust omay be its the nature of the beast anyone had the same
  3. Ok I will look for them someone on here will undoubtedly know what's needed to set them up and I'm already fitted with a nice Yoshi pipe
  4. Hello folks a newbie in need I have been trawling through the interchangable carb thread and fried my brain I have a 750 inazuma with a butchered float valve seat and believe they are not repairable so I'm looking for the easiest option to solve my problems Many thanks So I've seen the gsf 600 2000 to 2004 carbs on inlet and air box are exactly the same size also measure from front to back the same, has any one fitted these to the 750 Zuma ? Before I go and waste wages on a set ?
  5. What I didn't mention like a fool is I have the 750 inazuma , I am however having a little luck the seat is now out and to take another out to get decent measurement new ones are being made hopefully they press in on
  6. Ideally just want to a carb swap but intrigued by the dot head is it a case of finding a donner head and carbs which will fit straight on ?
  7. I know this is an old thread I see certain carbs are similar what will go straight on without to much bother, some tool.has tried to remove valve seat on one of mine and messed it up the seats are pressed in and not available
×
×
  • Create New...