SiBag

The k appears to running nicely, looks like it was an iffy coil. Just need to find the tent and sleeping bag.

Now that's an idea..

If I can get the K running right I'll be there.

@Blubberspot on. I just had a nose in the tank, and ye there is a drain tube running through the tank from the filler cap recess. Cheers for the help.

Ok, dum question time. Yes I RTFM, and it's not clear. And yes I should have taken pictures before I pulled it apart. Putting the tank back on the k after 4 months or so. The tap has two fuel lines and a vacuum off the carb. But there is another connector on the tank that I can't figure out what it connects to. Heeeelllllppppppp.

Fek.

Coming together nicely..

Checkout allballsracing.com

I hate elastic trickery.

Any news on this. I've heard rumours that they want to charge £10 per bike for the privilege of displaying them.l

He's right you know, I've just measured a set of each. Hmmmm

It all in here

Just take the rocker cover off the v711 and you will soon find out if it's an 89 or later shim head.

I think the v711 is a GSXR 1127 and the v706 is a gsx1100 1988 1127

Be rude not to. I'm in.

@Paulm @davecara are we doing this year? I think the dates are 11th- 12th September 2021..

I'd be tempted to run two smaller coolers either side. I remember @vizmanlooking at doing something similar on his silver cross pram (old Street fighter project build)

I have seen on other forums FB pages etc a roll call for bikes. I believe the VJMC need a list of bikes and owner in about four weeks. Have we had paperwork through from them?

I should be able to bring something.

@Simbec1863now I see why you were after a single seat hump. Very nice.

I believe on the Blandit 1200 the head swap raises the compression by 1 or 1.5 points due to the smaller combustion chamber in the DOT head. I suspect it will be similar for the N motor (potentially up around 11 to 11.5 : 1), but I'm sure an adult will correct me shortly..

OK lets clear a bit of the confusion. The DOT head was used on the 750 Tpot (up to 97 I think) and on the GSXR 750 J/K 1988 to 1989 The 750 Tpot cams are the cams that are described as "Soft" and not the best for performance. The GSXR 750 J/K and the GSXR 1100 K share the same cams (Part numbers 12721-17C00 exhaust, 12711-06B03 inlet) These are the cams you want to use.

Impressive....

I think the K7 is a 25mm spindle. But captive top hat spacers will sort that out. 750 runs a 180 tyre, so should be a 5.5 rim.

Dirty sounding carbs....