Engine mounts for a GSX1100 to take a GSX-R engine.

GSX-R engine mounts for GSX frames.
Below are drawings of engine mounts to fit an early air-cooled GSX (round frame tubes) or EFE (square frame tubes) with a GSX-R engine.
Both place the engine in the middle which is aesthetically best but may cause some problems with the exhaust headers interfering with the frame downtubes, which can be solved by using spacers or modifying the headers if necessary.

Engine mounts for a GSX1100 frame to take a GSX-R engine.
By "jonboy"

Click on image to load full-scale drawing.

A Katana with the above engine mounts installed...

Engine mounts for a GSX1100EFE (GS1150) to take a GSX-R engine.
By "GJG"

Below are drawings from the engine mounts, as I used them a few years back. I built at least two EFE’s using these plates. They mount the engine pretty straightforward, like in the Katana I send you pics from a few months back. I also included the cutting contours in .dxf format, that could straight be fed into a laser.

Parts description:	JPEG image	DXF drawing
PL-105 and 106: Take front rubber engine mount, and lower below crank. Need shims or bushes to compensate for offset.	PL-105 PL-106	PL-105 PL-106
PL-107 and 108: These should be welded in with the engine or cases in place, mounted with the previous mentioned plates. PL-108 is a bit long, and could do with a brace, taking sideward loads to the cross tube from the shock. The stock plate should be removed. The lower cross tube in the frame will need some cleaning up and removing of the stock lower rear plates, before taking PL-107.	PL-107 PL-108	PL-107 PL-108
PL-110 and 111: These make the removable, welded upper rear engine mount taking loads to the stock bolt holes/bushings welded into the side of the frame.	PL-110 PL-111 Assembly	PL-110 PL-111

Pictures of an EFE with above engine mounts...