Jump to content

Rsk_141

Members
  • Posts

    240
  • Joined

  • Last visited

Everything posted by Rsk_141

  1. Brilliant Tony cheers, got the carbs off today, will try it tomorrow . .
  2. Got some Gs 550 vm carbs running k&n and after market 4into1 swapped out jets book tells me air screw should be 2 turns out as a start point . It also states Fuel screw is set at factory and shouldn't be moved, "well that ship has sailed" I was thinking 2 turns out as well any advise would be great .
  3. I found this paint to be spot on::
  4. I'm heading over next Saturday got the zuma booked for a run to check fueling . Might see you there .
  5. This Time it was off to the Dyno At Dynotech Ecosse good day out highly recommend . Not bad for a 34 yr old bike . .
  6. It a gs 550 I have with the block number not the 1-6 . So a efe uses the same gear indicator? Lights
  7. Tell me more ! I have a gear indicator that's not right .
  8. Quick run out to Balloch, A82 Mmm! .
  9. One advantage of living in Glasgow! ( Apart from the obvious) that it's l Been chucking it down! So Mostly washed away .
  10. Spring Has Sprung! Any pics of days out welcome! Here's mine :
  11. Unfortunately They don't do one for the 550 . Looks great .
  12. That's a very nice zorst which one is it?
  13. Cheers Poldark, I've tried a 650L grabrail and it was too narrow I'll put it on the back burner for now! And hopefully some thing pops up . PS. Do you have an XJ?
  14. I'm not sure .I've got a lift handle for it, but I've seen a couple of bike with full bars over the tail piece . there's a GS on Eblag that has one
  15. Can any one help would like a Grab rail for a GS 550 Std not custom, Seen on a few bikes but can't seem to find one, Seen GT 750 / GT 500 rails for sale contacted seller they were not keen to give dimensions to see if it would fit . Bought a couple that looked ok but alas no, so cut one up to see if I could make it fit, all I got is a blunt hacksaw and some expensive scrap . tried looking for someone to make one not much luck. Any help in this matter would be amazing . Put a wanted add up also .
  16. Thanks for the reply, I was sure I heard the R1 tap fitted but 10mm difrence is a lot, dam looks like I will have a look at the pingle stuff I know that not going to be a cheap fix. .
  17. Gsxr 11 Micki 34mm tintops pull only Gsx 1200 34 mm kehi pull / push
  18. My tank has 50mm center's if this is any help .
  19. Which one does the R1 tap fit? And which R1 Tap fits that tank ?
  20. Hi, Just got a Slabby Tank need a fuel tap I have seen that some folk have mentioned that the R1 fuel tap fits which one is the right one? I know the R6 one disny fit . Any help would be great . It an early tank I think . .
  21. Little deeper tone, that's all .
  22. Bought this off Deutschee-blag ages ago, looked like a Mach7 bit rainy so see if it fits? Result looks much better than the cobra I think . .
×
×
  • Create New...