Hi all,
Great thank you.
Thanks FBOB for the pics, just what I needed and as I am in no rush I like the idea of fitting it up first then organising the fittings.
Thanks all
Hi all,
I will start a project thread soon but I have bought a Mk1 750 Teapot for a charity challenge.
It needs a new tank which has been offered by a very generous Mr FBOAB but I also need a new oilcooler. Yes I could buy a 2nd hand one but in this case I would rather have a new one on the grounds I don't want to replace a knackered one with another knackered one.
Any recommendations for suppliers of said items (other than Suzuki of course) and do I need a certain spec'?
Many thanks
Hi all,
Am looking at buying some stainless bends to make a header manifold but am concerned about cutting the stuff.
What grade of stainless is preferred (304?) and what do you use to cut it?
Hi Clive,
Apologies, my question was whether yours were 16.5" as I must of missed that detail, mine are 17 so no problem.
Didn't the Desmosedeici have 16.5 wheels and special Pirelli tyres but not sure if the rear would be too wide for your rim?
Please excuse my ignorance, but doesn't MS 3 do fuel and spark? If this is the case why would you run a separate ecu for the spark when you can manage both from one ecu?
Check out Jay Dexter on facebook as he makes made to measure race leathers for a lot of the supermoto guys, not seen the grade of leather he uses but has a good rep amongst these guys.